How To Alter Existing Roof Trusses For An Attic Room

There are a few ways to alter existing roof trusses for an attic room. The simplest way is to add a ridge board, which is a piece of lumber that spans the length of the roof and sits on top of the two end rafters. The ridge board can be used to attach new roof rafters to, creating the needed space for an attic room. Another way to create attic space is to add new trusses to the existing roof. This involves creating a new frame

How To Alter Existing Roof Trusses For An Attic Room

There are a few ways to alter existing roof trusses for an attic room. One way is to add more support members to the trusses, such as by installing additional lumber between the trusses. Another way is to use metal plates to fasten the trusses together, which will add strength. Additionally, you can add insulation between the trusses to help keep the new attic room warm.

-Tape measure -Circular saw -Plywood -Ruler or a straight edge -Stapler -Hammer -Pins -Nail Gun -Paint or Stain -Paintbrush – Safety Glasses

  • Measure the width and length of the area where you want to add the room
  • Find the roof trusses in the attic
  • Use a saw to cut the roof trusses along the lines that you have measured

on ‘how to alter existing roof trusses for an attic room’: -If the attic will be used as a bedroom, it is important to ensure that the roof trusses are adequate to support the additional weight. -If the attic is to be used for storage, it is not necessary to make any alterations to the roof trusses. -If there is not enough headroom in the attic, the roof trusses may need to be altered to create more


Frequently Asked Questions

Can You Convert A Trussed Roof?

Yes, it is possible to convert a trussed roof.

Can You Turn An Attic With Trusses Into A Room?

Yes, you can turn an attic with trusses into a room, but you will need to do some additional framing to create the walls and floor.

How Do You Finish A Truss In An Attic?

The easiest way to finish a truss in an attic is to use the ridge cap. The ridge cap is a piece of lumber that is cut to fit the ridge of the roof and is nailed in place.


To Review

To alter an existing roof truss for an attic room, one would need to measure the length and width of the desired room, then cut the appropriate number of lumber boards to fit that specific space. The boards would be nailed together to create the new roof truss, then installed in place of the original.

Leave a Comment

Your email address will not be published. Required fields are marked *