How To Cap Brick Wall

The following is a guide on how to cap a brick wall. To cap a brick wall, start by measuring the height and width of the wall. Next, purchase enough bricks to cover the entire wall. Before laying the bricks, make sure to apply mortar to the top of the wall. Then, lay the bricks in a staggered pattern and press them firmly into the mortar. Finally, allow the mortar to dry before applying a sealant.

How To Cap Brick Wall

Brick walls can be capped with a variety of materials, depending on the look you are trying to achieve. A simple cap of concrete or mortar can be used to cover the top of a brick wall, or you can use stone, tile, or another material. If you are using a different material for the cap than was used for the wall, it is important to make sure that the cap is properly sealed so that water does not seep through and damage the brick.

-Bricks -Mortar -Cape -Trowel -Sponge -Water bucket -Wire brush

  • Clean the surface of the brick wall to be capped
  • Add mortar to the top of the brick wall
  • Place a brick on top of the mortar use a trowel to smooth out the mortar and remove any excess

-Check the mortar between bricks for any cracks or missing chunks – If there are any, use a trowel to fill them in and smooth out the surface – Apply a layer of mortar over the entire surface of the wall – Use a bricklayer’s trowel to press it into the gaps between bricks and remove any excess – Allow the mortar to dry for at least 24 hours before applying capping


Frequently Asked Questions

How Do You Cap The Top Of A Stone Wall?

There are a few ways to cap the top of a stone wall. One way is to use a piece of flat stone, called a capstone, and fit it into the top of the wall. Another way is to use a piece of metal, called a coping, to fit over the top of the wall.

What Can I Use To Cover A Brick Wall?

There are many different ways to cover a brick wall. You could use wallpaper, paint, or even fabric.

How Do You Cap Off A Block Wall?

One way to cap a block wall is to use a concrete cap.


In Closing

A capped brick wall is a great way to finish off your project and protect the brick from weathering. You can either use a mortar mix to create a mortar cap or use pre-made caps. Make sure that the mortar or cap is properly sealed to keep water out.

Leave a Comment

Your email address will not be published. Required fields are marked *