How To Cut Plastic Toilet Shims

Plastic toilet shims are used to level a toilet by adding or removing shim material until the toilet is level. To cut a plastic toilet shim, use a sharp utility knife to cut the plastic along the marked line.

How To Cut Plastic Toilet Shims

Plastic toilet shims can be cut with a hacksaw. First, mark the desired length of the shim on the plastic with a permanent marker. Then, use a hacksaw to cut the shim to the desired length. Be sure to wear safety goggles when using a hacksaw.

-Tape measure -Ruler or a straight edge -Utility knife -Plastic toilet shims

  • Cut a piece of plastic toilet shim to the desired length with a sharp blade
  • Bend the shim along the scored lines until it snaps
  • Score the shim with the blade in a crisscross pattern

-The size of the shim will affect the ease of use. A smaller shim is more difficult to use than a larger one. -If the shim is too small, it may not be effective in leveling the toilet. -If the shim is too large, it may not fit into the space between the toilet and the floor.


Frequently Asked Questions

How Do You Use Plastic Shims To Level A Toilet?

To level a toilet, you can use plastic shims. You would first remove the toilet lid and then place the shims underneath the base of the toilet. You would then adjust the position of the shims until the toilet is level.

How Do You Level A Tile Under A Toilet?

There are a few ways to level a tile under a toilet depending on the existing floor. One way is to use shims placed under the toilet’s base to achieve a level surface. Another way is using adhesive and levelling compound to create a level surface before installing the tile.

What Do You Put Under Toilet Level?

In order to prevent water from seeping out from under the toilet, you can put a piece of cinder block or a brick under the toilet’s base.


In The End

There are a few ways to cut plastic toilet shims. One way is to use a utility knife. Another way is to use a hacksaw.

Leave a Comment

Your email address will not be published. Required fields are marked *