How To Dig Under Sidewalk

There is no one definitive way to dig under a sidewalk. Several methods are possible, depending on the materials and construction of the sidewalk. One method is to use a jackhammer to break through the concrete. This is a noisy and dusty process, and requires heavy equipment. It is also possible to use a chisel and hammer to chip away at the concrete, or to use a chainsaw to cut through it. Another method is to drill holes in the sidewalk and

How To Dig Under Sidewalk

If you need to dig under a sidewalk, the best way to do it is by using a shovel. Begin by marking the area where you will be digging with some spray paint or stakes. Next, use a shovel to loosen the soil in that area. Be sure to go deep enough so that you can fit the shovel underneath the sidewalk. Once the soil is loose, use a crowbar or hammer to break up any large chunks. Finally, remove the debris and replace the soil.

– Shovel – Rake – Wheelbarrow – Level – Tape measure – Hammer – Pry bar

  • Measure the width and depth of the sidewalk
  • Get a shovel that is equal to or larger than the width of the sidewalk
  • Dig a trench equal to the depth of the sidewalk on one side of it

below -check for any underground utility lines before digging -use a shovel to dig a trench along the edge of the sidewalk -use a pry bar or hammer to break up the concrete and remove it from the trench -dig down to the desired depth and remove any additional soil -place supports under the sidewalk to hold it up while you’re working -reinforce the supports with metal brackets once the work is done


Frequently Asked Questions

How Do You Dig Under A Concrete Walkway?

There are a few ways to dig under a concrete walkway – you can use a jackhammer, a chisel and hammer, or a power drill.

How Do I Dig Irrigation Under Sidewalk?

There are a few ways to dig irrigation under sidewalks. One way is to use a jackhammer to break up the concrete. Another way is to use a spade and shovel to dig out a trench.

How Deep Should Irrigation Lines Be Buried?

Ideally, irrigation lines should be buried at least 18 inches deep to avoid freezing in cold climates and to protect them from damage.


In The End

Digging under a sidewalk can be a challenge, but it can be done. The first step is to identify the point where the sidewalk meets the ground. Once this is found, use a shovel to dig a trench along the edge of the sidewalk. Be sure to go deep enough so that the entire width of the shovel blade is below the concrete. Once the trench is dug, use a pry bar to break up the concrete and remove it. Finally, fill in the hole with soil and pack it down firmly.

Leave a Comment

Your email address will not be published. Required fields are marked *