How To Fix Pex Pipe Hole

PEX pipe is very durable and easy to install, but it can be prone to holes. There are a few ways to fix a hole in PEX pipe. One way is to use a sleeve clamp. This clamp is inserted over the pipe and the hole is clamped shut. Another way to fix a hole in PEX pipe is to use a screw clamp. This clamp has a screw that tightens down on the pipe and closes the hole.

How To Fix Pex Pipe Hole

There are a few ways that you can fix a hole in a PEX pipe. One way is to use a plumbing clamp. This is a metal clamp that you can use to tighten around the pipe to seal the hole. Another way to fix the hole is to use a piece of PEX tubing. This is a piece of tubing that is the same size as the PEX pipe. You can use this piece of tubing to cover the hole and then seal it with plumber’s

-Pex pipe -Pipe cutter -Pipe wrench -Crimping tool -Hacksaw -Tape measure -Marker -Pipe sealant

  • Cut a new piece of pex pipe to fit the hole using a hacksaw
  • Use pliers to crimp the pex pipe onto the
  • Using a screwdriver, pry off the broken piece of pex pipe

below: -Clean the area around the hole with a wire brush -Apply pipe adhesive to the edges of the hole -Press the patch over the hole and hold in place for 30 seconds -Apply more adhesive to the top of the patch and let dry


Frequently Asked Questions

Can You Patch A Hole In Pex?

Yes, it is possible to patch a hole in PEX. First, cut a piece of PEX that is slightly larger than the hole. Then, use a heat gun to heat up the PEX until it is soft. Finally, insert the PEX into the hole and use a clamp to hold it in place.

What Causes Pinhole Leaks In Pex Pipe?

Pinhole leaks in PEX pipe can be caused by a number of things, including improper installation, corrosion, and heat damage.

How Do You Fix A Pinhole Leak In A Plastic Pipe?

The best way to fix a pinhole leak in a plastic pipe is to use a hot glue gun.


In Summary

If you have a hole in your PEX pipe, you can fix it by using a PEX patch clamp. To do this, first remove the damaged section of pipe and cut a new section to fit. Then, use a deburring tool to remove any burrs from the cut edges. Next, slide the patch clamp over the end of the pipe and fit the rubber gasket over the hole. Finally, tighten the screws on the clamp to secure it in place.

Leave a Comment

Your email address will not be published.