How To Flare A Copper Gas Line

Flaring a gas line is a process that is used to prevent gas from escaping from a pipe. This process is done by using a flaring tool to create a cone-shaped flare on the end of the pipe.

How To Flare A Copper Gas Line

Flaring a copper gas line is a process of connecting the copper gas line to the gas meter in order to allow the natural gas to flow into the home. The first step is to cut the copper tubing to the desired length using a tubing cutter. Next, use a pipe wrench to loosen the coupling nut on the gas meter. Slide the copper tubing over the coupling nut and tighten the coupling nut with the pipe wrench. Finally, turn on the natural gas and check for any leaks. If

-Flared copper gas line -Tape measure -Pipe cutter -Pipe wrench -Propane torch -Safety goggles -Gloves

  • Measure and mark the copper pipe where you will be flaring it place the copper pipe in the flaring tool and tighten down the
  • Clean end of copper pipe
  • Flare copper gas line using a flaring tool

-Flaring a gas line is a process of connecting the line to a pipe fitting, often called a flare union, in such a way that gas can escape. -When flared, the end of the gas line is heated until it glows red and then quickly quenched with water. -This creates a sharp, V-shaped ridge on the end of the line which seals it and prevents gas from escaping. -A flared gas line should be installed


Frequently Asked Questions

Where Would You Install Flared Connections?

A flared connection is a type of pipe fitting used to connect two pipes together. The pipes are first joined together using a coupling, and then the flared end of the fitting is inserted into the coupling. The flared end is then crimped to hold it in place.

Does Copper Tubing Need To Be Flared?

No, copper tubing does not need to be flared. Tubing can be connected using compression fittings, flare fittings, or threaded fittings.

How Do You Install A Copper Flare Fitting?

To install a copper flare fitting, you will need to have a flared fitting, flux, solder, and a torch. First, clean the copper fitting and the flare fitting of any oils or dirt. Apply flux to both the copper fitting and the flare fitting. Solder the copper fitting to the flare fitting. Heat up the flare fitting with the torch until it is red hot. Quickly put the solder on top of the flare fitting and let it melt. Once the solder has melted, remove the torch.


In Closing

When flaring a copper gas line, use a pipe cutter to cut the line cleanly. Use a propane torch to heat the copper until it turns bright red. Use a wrench to twist the flare fitting onto the end of the copper pipe. Hold the flare fitting with pliers and use the torch to heat it until it glows orange. Twist the fitting until it is tight.

Leave a Comment

Your email address will not be published. Required fields are marked *