How To Get Drain Snake Past Trap

If you’re trying to get a drain snake past a trap, the easiest way is to remove the trap. However, if you can’t remove the trap or don’t want to, you can try to go around it. If the drain snake is too big to go around the trap, you’ll need to remove it.

How To Get Drain Snake Past Trap

One way to get a drain snake past a trap is to insert it into the drainpipe above the trap and then lower it down until it reaches the trap. You can also try using a plumber’s helper to lift the trap out of the way so that you can snake the drain.

-A drain snake -A trap -Tongs or a wrench to hold the trap -A bucket

  • Place the snake over the drain and push it down as far as it will go
  • Once the snake is through the trap, pull it out of the
  • Twist the snake around to work it past the trap

below There are a few different ways that you can go about getting your drain snake past the trap. One way is to remove the trap entirely and snake the drain from above. This can be a bit tricky if the trap is in a tight spot, but it is possible. Another way to get around the trap is to use a flexible auger. This will allow you to snake the drain without having to remove the trap.

Frequently Asked Questions

How Do I Get My Drain Snake To Turn A Corner?

There are a few ways to get your drain snake to turn a corner. One way is to use a tool called a “drain auger” or “plumber’s helper.” This is a tool that has a curved metal shaft with a spiral blade on the end. You can also use a standard screwdriver to help turn the drain snake. Another way to turn the snake is to hold the snake at an angle and twist it as you push it down the drain.

What To Do When You Can T Snake A Drain?

If you can’t snake a drain, the most likely solution is to pour boiling water down the drain. This will clear most clogs. If that doesn’t work, try using a plunger. If that still doesn’t work, you may need to call a plumber.

How Do You Get A Snake Past 90 Degrees Turn?

Some people recommend gently guiding the snake around the turn, using a stick if necessary. Others recommend propping up one end of the snake’s body so that it can “curl” around the turn.

To Summarize

The best way to get a drain snake past a trap is to use a plumbing plunger. Place the plunger over the opening of the drain and push and pull the plunger until the snake is able to go through.

Leave a Comment

Your email address will not be published. Required fields are marked *