How To Get Nails Out Of Deck Boards

There are a few ways to remove nails from deck boards. One is to use a hammer to gently pound the nail until it pops out. Another is to use a pry bar or screwdriver to wedge the blade under the nail head and lift it up. A third way is to use a drill with a Phillips head bit to remove the nail.

How To Get Nails Out Of Deck Boards

There are a few ways to get nails out of deck boards. One way is to use a claw hammer to slightly lift the nail and then use a screwdriver or pry bar to pull the nail out. Another way is to drill a hole in the head of the nail and then use a crowbar to pry the nail out.

-Tape measure -Pry bar -Hammer -Nail puller

  • Use pry bar to remove deck board
  • Cut deck board at screw or nail
  • Remove screws or nails from deck board

-If nails are protruding from the deck board, use a hammer to drive them back in so they are flush with the deck board. -If nails are sunken into the deck board, use a pry bar to gently remove them. -If nails are difficult to remove, use a drill with a Phillips head bit to remove them.


Frequently Asked Questions

Is It Better To Nail Or Screw Deck Boards?

There is no clear answer, as both nailing and screwing have their pros and cons. Nailing is faster and easier, but screws are more secure.

How Do You Remove Screwed Deck Boards Without Damage?

The easiest way to remove a screwed deck board is with a pry bar. Place the pry bar between the deck board and the joist and pry the board up. If the board is stubborn, you can use a hammer to tap the pry bar until the board pops off.

Should I Replace Deck Nails With Screws?

Replacing deck nails with screws is a personal preference, as both have their pros and cons. Nails can be faster to install, while screws are more secure and less likely to pull out.


In The End

The best way to remove nails from deck boards is to use a pry bar. Place the pry bar underneath the nail and use a hammer to tap it until the nail pops out. If there is a lot of paint or sealant on the deck boards, you can use a hacksaw to cut through the nail.

Leave a Comment

Your email address will not be published. Required fields are marked *