How To Install Densshield

Densshield is a synthetic insulation product that is used to insulate attics, walls, and ceilings. It is made of fiberglass and resin, and it can be installed in a variety of ways depending on the project.

How To Install Densshield

DensShield is a tile backer made from extruded polystyrene foam and cement. It is available in 4×8-foot sheets and is used to provide a surface for ceramic tile installation. DensShield is also moisture resistant, which makes it ideal for use in bathrooms, kitchens, and other areas where moisture may be present. To install DensShield, you will need the following tools: utility knife, straight edge, hammer, screwdriver, level, tape

-Tape measure -Plywood -Circular saw -Ruler or a straight edge -High density foam insulation -Staple gun -Staples -Scissors -Cordless drill -1 inch hole saw -Paintbrush -Construction adhesive -Silicone caulk -Lumber (2x4s, 2x6s, and a piece of 3/

  • Densshield is a tile backerboard designed to be used as a waterproofing layer in showers and bathrooms
  • It can be cut with a standard utility knife and installed with standard roofing nails or screws

– ensure the surface is clean and free of debris – measure and mark the area to be covered – cut the densshield to size – apply an adhesive to the back of the densshield – place the densshield in position – smoothe out any air bubbles


Frequently Asked Questions

What Kind Of Screws Do You Use With Densshield?

You would typically use Phillips or slotted screws when installing DensShield.

How Do You Use Redgard On Densshield?

Redgard is a tile adhesive and sealant which can be used on DensShield to provide a watertight seal. It is applied in two coats, the first of which is a bonding agent, and the second of which forms the waterproof seal.

Can You Finish Densshield?

Yes, DensShield can be finished. However, it is important to follow the proper steps and use the correct products to ensure a quality finish.


In The End

Densshield is a tile backer board that is installed using screws and mortar. It is a good choice for bathrooms, kitchens, and other areas where moisture is likely to occur.

Leave a Comment

Your email address will not be published. Required fields are marked *