How To Join Two Pieces Of Drip Edge

There are a few ways to join two pieces of drip edge. One way is to overlap the pieces and use a piece of flashing or duct tape to seal the joint. Another way is to use a gutter clip or roofing nails to fasten the pieces together.

How To Join Two Pieces Of Drip Edge

There are a few ways to join two pieces of drip edge. The most common way is to overlap the two pieces and then use a screw or nails to hold them together. Another way is to use a connector piece, which can be found at most home improvement stores.

-Drip edge (aluminum or galvanized) -Tape measure -Pruners -Circular saw -Jigsaw -Drill -1 inch hole saw -Paintbrush -Exterior grade silicone sealant -Caulking gun

  • Measure and cut drip edge to the desired length
  • Slide gutter over top of newly
  • Hold drip edge in place and hammer in nails along the top of the roof edge
  • Apply roofing cement to the nail heads and smooth out

-The drip edge should be cut to fit the length of the roof -There should be a gap of at least 1/2″ between the two pieces of drip edge -The overlap of the two pieces of drip edge should be at least 6″


Frequently Asked Questions

How Do You Overlap A Drip Cap?

One way to overlap a drip cap is to ensure that the top of the cap is even with the top of the siding. You can then use nails or staples to secure the drip cap in place.

Can You Install Drip Edge Over Existing Drip Edge?

You should not install drip edge over existing drip edge. Doing so may trap water and cause the metal to corrode.

Can You Extend The Drip Edge?

Yes, you can extend the drip edge.


In Summary

Adding drip edge to the roof is a simple process that helps keep water from flowing behind the shingles and seeping into the attic. There are a few ways to join two pieces of drip edge, but the most common is to use a metal connector clip. The clip is nailed in place along the joint between the two pieces of drip edge, then the edges are folded over and crimped shut.

Leave a Comment

Your email address will not be published. Required fields are marked *