How To Make A Mortise Lock Jig

A mortise lock jig is a device used to create a mortise, or hole, for a mortise lock in a door. The jig typically consists of a wooden base with a guide for the drill bit and a clamp to hold the door in place.

How To Make A Mortise Lock Jig

There are a few ways to make a mortise lock jig. One way is to use a router and a straight edge. The router is set up so the bit is just touching the straight edge. The mortise is then routed out using this setup. A jig can also be created using a drill and chisel. The drill is used to create the outline of the mortise and the chisel is then used to finish it off. Finally, a mortise lock jig

-Tape measure -Plywood sheet -Circular saw -Ruler or a straight edge -Pencil -Jigsaw -Drill -1 inch hole saw -Paint or a sealant -Screws -Hinges -Latch -Knob or handle -Lock

  • Using a piece of wood, draw the outline of the mortise lock on it
  • Cut out the shape of the mortise lock using a jigsaw
  • Drill guide holes in the jig using a drill bit that is

-A mortise lock jig can be made out of a piece of scrap wood. -The dimensions of the jig should be such that the mortise in the jig is slightly smaller than the width of the lock and the depth of the jig is equal to the length of the lock. -The jig should have a hole drilled in it at the center of its width and depth which will accommodate a drill bit. -The drill bit should have a diameter


Frequently Asked Questions

How Do You Cut A Mortise Lock With A Router?

There are a few different ways to cut a mortise lock with a router. One way is to use a straight bit and cut a groove in the door where the lock will go. Another way is to use a template to create the shape of the lock, and then use a spiral bit to rout it out.

How Do You Make A Router Jig For A Door Latch?

To make a router jig for a door latch, you need a straight piece of wood at least 12″ long and 1-1/2″ wide. You also need a 3/4″ dowel or bolt that is at least 2″ long. First, mark the center of the wood and drill a hole in the center that is big enough for the dowel or bolt to fit through. Next, use a coping saw to cut out a rectangular opening around the hole that is big enough for the latch to fit through. Finally, use a router with a 1/4″ bit to rout a groove around the outside of the rectangle that is big enough for the latch to slide in.

What Size Hole Do I Drill For Door Latch?

When drilling a hole for a doorknob or door latch, you will want to use a drill bit that is the same size as the shaft of the knob or latch.


To Review

To make a mortise lock jig, one needs a piece of wood that is at least as wide as the lock body and the same height as the thickness of the door. The wood should also be long enough to accommodate both the lock body and the striker plate. The jig is then cut out using a band saw or jigsaw. A hole is drilled in the center of the jig for the lock cylinder, and two more holes are drilled on either side of the cylinder hole for the striker plate. The mortise lock jig can then be used to make accurate mortises for the lock body and striker plate.

Leave a Comment

Your email address will not be published. Required fields are marked *