How To Make A Plumbing Snake Turn Corners

In order to make a plumbing snake turn corners, one must first determine the direction in which they want the snake to go. next, they must insert the snake into the drain in order to get it to the clog. once the snake is around the clog, they must then twist the snake in the opposite direction of the clog in order to get it to move.

6 Steps to Make A Plumbing Snake Turn Corners

A plumbing snake is a long, flexible rod that is used to remove clogs from pipes. The snake is inserted into the pipe and then turned in a clockwise direction. As the snake is turned, it will wind around corners and curves in the pipe, breaking up the clog and allowing it to be flushed away.

One of the most important skills a plumber must learn is how to make a plumbing snake turn corners. This is because many pipes, especially in older homes, are not straight and can have a number of bends and turns. If a plumber does not know how to make a plumbing snake turn corners, they will not be able to properly clear the blockage and the problem will persist. Additionally, if a plumber is not careful, they could damage the pipe while attempting to clear the blockage, which would cause an even bigger problem.

Step 1: How To Make A Plumbing Snake Turn Corners

In order to make a plumbing snake turn corners, the person operating the snake will need to apply pressure to the handle in the direction that they want the snake to turn. The amount of pressure that is needed will vary depending on the type of snake being used as well as the size of the pipe that the snake is going through.

Step 2: Take A Piece Of Tubing And Curve It Around The Corner

Using a piece of tubing, curve it around the corner to form a snake. This will allow the snake to turn corners and reach tight spaces.

Step 3: Tape The Tubing In Place

If the tubing is not taped in place, it will not be able to make the necessary turns to snake around corners. Taping the tubing in place will help to ensure that it has the necessary flexibility to make the required turns.

Step 4: Secure The Snake To One End Of The Tubing

To make a plumbing snake turn corners, first secure the snake to one end of the tubing. Then, insert the snake into the tubing at the desired turning point. Next, twist the snake clockwise to rotate it and make it turn. Finally, pull the snake out of the tubing and repeat the process as needed.

Step 5: Feed The Snake Into The Tubing

Feeding the snake into the tubing helps the snake maneuver around corners in the pipe.

Step 6: Turn The Crank On The Snake To Make It Wind Through The Tubing

To make a plumbing snake turn corners, first crank the snake to make it wind through the tubing. Next, turn the crank in the direction you want the snake to go. Finally, push the snake forward until it goes around the corner.


Frequently Asked Questions

How Do You Get A Snake Around The Corner?

When you want to turn a snake around a corner, you need to use a sharp, quick movement. You need to grab the snake behind its head and then quickly twist its body in the direction that you want it to go.

How Do You Roll Up A Plumbing Snake?

To roll up a plumbing snake, start by holding the snake in one hand with the handle facing up. Then, use your other hand to hold the end of the snake and winding it around the handle. Continue winding the snake around the handle until it is completely rolled up.

In Closing

To make a plumbing snake turn corners, use a 90-degree elbow fitting. This will allow you to snake around tight corners without having to remove the fitting.

Leave a Comment

Your email address will not be published. Required fields are marked *