How To Make Plugs For Salt And Pepper Shakers

There are a few different ways to make plugs for salt and pepper shakers. One way is to use a small ball of clay, roll it into a thin rope, then coil it around the opening of the shaker. Another way is to use a small piece of wood or dowel, drill a hole in the center, then glue it in place.

How To Make Plugs For Salt And Pepper Shakers

There are a few different ways to make plugs for salt and pepper shakers. One way is to use a small cork. Cut the cork in half and then use a knife to cut a small hole in the center of the cork. This is the easiest way to make a plug, but the cork may become wet and fall apart over time. Another way to make a plug is to use a small piece of rubber tubing. Cut the tubing so that it is just

-A drill -A 1/4 inch bit -A 3/8 inch bit -Tape measure -Permanent marker -Ruler or a straight edge -Salt and pepper shakers

  • Roll up each piece of paper into a tight ball twist the top
  • Cut a small hole in the centre of each plug
  • Take two pieces of paper and cut out a shape for each plug using a craft knife

– consider the size of the opening on the shaker – consider the shape of the opening on the shaker – consider how much spice you want to add with each shake – consider how often you will be using the shakers


Frequently Asked Questions

Does Salt Or Pepper Go In The 3 Hole Shaker?

Salt and pepper are both used in many dishes, and so they are often put in a shaker together. However, some people prefer to put salt in the 3 hole shaker and pepper in the 4 hole shaker.

Does Salt Go In The 2 Hole Or 3 Hole Shaker?

Salt goes in the 2 hole shaker.

Which Holes Are Bigger In Salt And Pepper Shakers?

The holes in a salt shaker are typically bigger than the holes in a pepper shaker. This is because salt is a finer grain than pepper, so it needs smaller holes to ensure that it doesn’t fall through.


To Summarize

There are a few ways to make plugs for salt and pepper shakers. One way is to use a small cork. Another way is to use a small piece of rubber tubing.

Leave a Comment

Your email address will not be published. Required fields are marked *