When it comes time to move a bathtub drain in concrete, the first thing you need to do is identify the location of the sewer line. Once you have located the sewer line, use a chisel and hammer to chip away at the concrete around the drain until you expose the pipe. Use a hacksaw to cut through the pipe and then use a plumber’s wrench to remove the old drain. Finally, install the new drain by following the same steps in reverse.
How To Move A Bathtub Drain In Concrete
If you are moving a bathtub drain in concrete, the first step is to identify the existing drain. This can be done by locating the metal flange that is protruding from the concrete and tracing the outline of the flange with a chalk line. Once the outline is marked, use a drill to create a hole in the center of the flange. Next, use a chisel and hammer to break away the concrete around the flange until it is exposed. Use a
-trowel -flat head screwdriver -hammer -chisel -level -ruler or tape measure -pencil -concrete saw -safety glasses -ear plugs -dust mask -hard hat -steel toe boots
- Mark the spot where the current drain is located with a chalk line
- Drill a hole in the concrete
- Inspect the area where you want to move the bathtub drain and make sure there is enough room to work
– If the bathtub drain is set in concrete, it can be difficult to move. – The first step is to chisel around the drain using a hammer and chisel. – Once the perimeter is chiseled, use a crowbar to pry the drain out. – If the concrete is soft, a sledgehammer can be used to break it up. – Once the drain is free, use a jackhammer to break up the
Frequently Asked Questions
Is It Hard To Move A Bathtub Drain?
It can be hard to move a bathtub drain, depending on the model. Some drains are attached to the pipe below the tub with a slip nut, which can be loosened with a wrench. Others are connected with screws that must be removed. The drain cover and hair trap may also need to be unscrewed.
Can You Move A Shower Drain In Concrete?
It is possible to move a shower drain in concrete, but it requires some work. The first step is to identify the location of the shower drain and then use a chisel and hammer to break away the concrete around it. Once the drain is exposed, the clamps can be removed and the drain can be relocated.
How Hard Is It To Move A Bathtub Drain?
It can be hard to move a bathtub drain, especially if it is clogged. First, try using a plunger to clear the clog. If that doesn’t work, you may need to use a snake or a plumber’s helper tool to clear the drain.
In Closing
Removing and relocating a bathtub drain in concrete is a challenging project, but can be done with some basic tools and know-how. First, use a reciprocating saw to cut through the concrete around the drain. Then, use a chisel and hammer to break away the remaining concrete. Finally, use a drill and screwdriver to remove the old drain and install the new one.