How To Remove Anode Rod From Bradford White Water Heater

Bradford White water heaters use an anode rod to protect the tank from corrosion. Over time, the anode rod can become coated with sediment and minerals, which can reduce its ability to protect the tank. If your Bradford White water heater is not performing as well as it used to, you may need to remove and clean the anode rod.

How To Remove Anode Rod From Bradford White Water Heater

There are a few steps involved in the process of removing an anode rod from a Bradford White water heater. First, the power to the water heater must be turned off. The cold water supply line must then be shut off, and the drain valve opened to allow any water remaining in the tank to drain out. The tank can then be accessed by removing the access panel on the side or top of the unit. The anode rod can then be unscrewed and removed from the

-Anode rod removal tool -Channel locks -Wrench -A bucket -Protective gloves -Safety glasses

  • Loosen the anode rod by turning it counterclockwise with a wrench
  • Locate the anode rod on the bottom of the water heater
  • Lift the anode rod out of the water heater

below 1) Turn off the power to the water heater at the breaker box. 2) Close the cold water valve on the bottom of the tank. 3) Drain the tank by opening the drain valve at the bottom of the tank. 4) Remove the anode rod by unscrewing it from the top of the tank. 5) Replace the anode rod if it is corroded. 6) Screw the new anode rod into place and tighten it with


Frequently Asked Questions

What Type Of Anode Rod Does Bradford White Use?

Bradford White manufactures water heaters that use an anode rod made of magnesium.

How Do You Know If Anode Rod Is Magnesium Or Aluminum?

The anode rod is the metal rod located in the center of a water heater’s tank. It is responsible for attracting electrons to the tank and therefore, heating the water. The anode rod will corrode over time, which is why it needs to be replaced every few years. An easy way to tell if your anode rod is magnesium or aluminum is by its weight. Magnesium rods are heavier than aluminum rods.

How Do You Loosen A Stuck Anode Rod?

Loosen the anode rod by gently tapping it with a hammer.


To Review

Removing the anode rod from a Bradford White water heater is a relatively simple process. The anode rod can be removed by loosening the two hex screws that hold it in place. The anode rod can then be pulled out of the water heater.

Leave a Comment

Your email address will not be published.