Removing a concrete fence post can be a difficult task. A car jack can be used to help remove the post. The jack should be placed under the post and then slowly raised until the post pops out of the ground.
How To Remove Concrete Fence Post With Car Jack
Removing a concrete fence post can be a difficult task. It can be done using a car jack, though. The process is as follows: 1. Determine where the post is located in the ground. This can be done by digging around the post until you find the bottom. 2. Place the car jack over the post and slowly raise it until the post pops out of the ground. 3. Use a shovel to remove any remaining concrete from around the
-Car jack -Wrench or socket set -Pry bar -Hammer -Chisel – Safety glasses
- Remove the concrete fence post with a crowbar
- Use the car jack to pry open the concrete fence post
- Break up the concrete around the fence post with a sledgehammer
1. Make sure the car jack is stable before you start jacking the post up. 3. Insert the car jack at the base of the post and raise it until the post pops out of the ground. 4. If the concrete is still attached to the post, use a hammer and chisel to break it off.
Frequently Asked Questions
How Do You Remove A Broken Post From The Ground?
There are a few ways to remove a broken post from the ground. One way is to use a post puller to grab the post and pull it out of the ground. Another way is to use a backhoe to dig around the post and lift it out of the ground.
What Is The Easiest Way To Remove Fence Posts From Concrete?
There are a few ways to remove fence posts from concrete. One way is to use a post hole digger to dig around the post and then use a crowbar to pry it out. Another way is to use a sledgehammer to break the concrete around the post and then use a crowbar to pry it out.
How Do You Remove Rotted Fence Posts From Concrete?
There are a few ways to remove rotted fence posts from concrete, but the most common is to use a post hole digger.
Taking Everything Into Account
Removing a concrete fence post with a car jack is a relatively easy process. First, use a saw to cut the top off of the post. Next, use a chisel to break away the concrete around the base of the post. Finally, use a car jack to lift the post out of the ground.