How To Remove Excess Polymeric Sand From Pavers

Polymeric sand is a granular material that is used to stabilize and bind pavers in place. It is applied to the joints between pavers, and when it dries, it hardens, locking the pavers in place. Polymeric sand can be difficult to remove when it becomes excess, but there are a few methods that can be used.

How To Remove Excess Polymeric Sand From Pavers

There are a few ways to remove excess polymeric sand from pavers: One way is to sweep it off with a broom. Another way is to rinse it off with a hose. A third way is to use a power washer.

– Shovel – Wheelbarrow – Polymeric sand – Water – Broom

  • Sweep excess sand from pavers using a broom
  • Rinse pavers with a garden hose
  • Vacuum up any remaining sand

-Sweep or blow off excess sand. -Hose off remaining sand. -If needed, use a power washer to remove any remaining sand.

Frequently Asked Questions

Do I Need To Remove Old Polymeric Sand?

The short answer is no, you do not need to remove old polymeric sand. However, if you are installing a new layer of polymeric sand, you will need to remove the old layer first.

Can You Add Another Layer Of Polymeric Sand?

No, adding another layer of polymeric sand is not recommended. It is likely that the added layer will not bond correctly to the underlying layer, which could lead to premature failure of the surface.

What Do You Do With Extra Polymeric Sand?

Extra polymeric sand can be stored in a sandbox or other designated area.

To Summarize

Polymeric sand is a great way to seal pavers and keep them looking new. However, if too much is applied, it can be difficult to remove. The best way to remove excess polymeric sand is by using a broom or brush to sweep it off the surface. If the sand is caked on, a little water may help loosen it up.

Leave a Comment

Your email address will not be published. Required fields are marked *