Removing a floor outlet is a relatively simple process that can be completed with a few basic tools. First, remove the cover plate from the outlet. Next, use a screwdriver to remove the screws that hold the outlet in place. Finally, pull the outlet out of the hole and disconnect the wires.
How To Remove Floor Outlet
Floor outlets are a convenient way to provide power to a room, but they can be difficult to remove if you need to relocate them. The process usually involves prying the outlet out of the floor with a screwdriver or chisel, then cutting the wires and removing the screws that hold the outlet in place. If you’re careful, you can avoid damaging the flooring while removing the outlet.
-Tape measure -Flathead screwdriver -Phillips head screwdriver -Pry bar -Hammer -Putty knife -Chisel -Circular saw
- Remove the screws that are holding the plate in place
- Start by flipping the breaker off that is supplying power to the outlet
- Carefully pull the outlet out of the hole
below -Check to see if the outlet is GFCI-protected by pressing the test button. If it’s not, trip the breaker that powers the outlet and replace the outlet with a GFCI-protected model. -Remove the cover plate from the outlet. -Remove the screws that hold the outlet in place. -Pull the outlet out of the wall and disconnect the wires. -Thread the new wires through the hole in the wall and reattach the outlet
Frequently Asked Questions
Are Floor Outlets A Good Idea?
Floor outlets are a good idea because they are more convenient than wall outlets. They are also less likely to be blocked by furniture.
Can I Remove A Floor Outlet?
Yes – but it’s important to remember to shut off the power at the breaker before starting any work!
How Do You Move A Floor Outlet?
There are a few ways to move a floor outlet. One way is to use a power drill to drill through the outlet and the floor. Another way is to cut out a square around the outlet and remove it. The new outlet can then be installed in the hole.
Removing a floor outlet is a relatively easy task. First, remove the cover plate from the outlet. Then, use a screwdriver to remove the screws that hold the outlet in place. Once the screws are removed, pull the outlet out of the hole and disconnect the wires. Finally, reconnect the wires to the new outlet and reattach the cover plate.