If your electric water heater is acting up, it may be time to reset it. This is a process that can be done by anyone, and only takes a few minutes.
How To Reset An Electric Water Heater
An electric water heater can be reset by turning off the power to the water heater at the breaker box and then waiting a few minutes before turning the power back on.
-electric water heater -Phillips head screwdriver -flat head screwdriver -pliers -putty knife -screwdriver
- Turn off the water supply to the water heater
- Open the pressure relief valve to release any pressure in the tank locate the thermostat on the water heater and
- Make sure the water heater is unplugged
-Check the breaker box to ensure that the heater’s circuit is turned on. -Locate the thermostat on the heater and set it to the lowest possible setting. -Unplug the heater from the wall outlet. -Wait at least 30 minutes for the water inside the tank to cool down. -Open a hot water tap in the house to release any pressure that has built up in the tank. -Locate the drain valve at the bottom
Frequently Asked Questions
How Long Does It Take For An Electric Water Heater To Reset?
It typically takes about five minutes for an electric water heater to reset after it has been turned off.
How Long Does It Take For Water Heater To Heat Up After Reset?
The average water heater will take about an hour to heat up after being reset.
Do Electric Water Heaters Have A Reset Button?
Electric water heaters do not have a reset button. If the water heater does not operate, the breaker may have been tripped. Resetting the breaker should restore power to the water heater.
When resetting an electric water heater, be sure to turn off the power to the heater at the breaker box. To reset the heater, locate the reset button on the front or top of the unit and press it. Once the button has been pushed, turn on the power to the breaker box and wait for the heater to come back on.