There may be times when you need to reset the pressure switch on your well pump, for example if it has been tripped. This can be done without the use of the lever, although it may be a little more difficult.
How To Reset Well Pump Pressure Switch Without Lever
There are a few ways to reset a well pump pressure switch without the lever. One way is to use a flathead screwdriver to gently pry the switch open. Another way is to use needle-nose pliers to grasp the switch and pull it open.
-Need Phillips head screwdriver -Need adjustable wrench -Need Crescent wrench -Need hammer -Need screwdriver or drill -Need wire cutters
- Turn off the breaker to the pump
- Using a flat head screwdriver, turn the pressure switch counter clockwise to release itonce released, pull the switch straight up and remove it
- Locate the pressure switch on the pump
Some tips on how to reset a well pump pressure switch without the lever include verifying that it is in the off position, locating the manual reset button, and pushing it in. It is also important to ensure that there is no water pressure in the system before resetting the switch. Another way to reset the switch is by disconnecting and then reconnecting the power supply.
Frequently Asked Questions
How Do I Reset My Pressure Switch?
To reset the pressure switch, locate the small black button on the switch and press it in with a pen or paperclip.
How Do You Bypass A Pressure Switch On A Well Pump?
There could be a few ways to bypass a pressure switch on a well pump. One way could be to jumper the two wires together on the pressure switch. Another way, which is not recommended, would be to remove the pressure switch and drill a hole in the pipe leading to the pump and insert a plug.
How Do You Reset The Pressure Switch On A Well Pump Without A Lever?
There is no definitive answer to this question as it depends on the specific pressure switch and well pump in question. However, some possible methods include using a screwdriver to adjust the screw on the switch, or prying off the cover of the switch and manually pushing the reset button.
In Summary
Resetting the pressure switch on a well pump is a simple process that can be done without the use of any tools. First, turn off the power to the pump at the breaker box. Next, locate the pressure switch and turn the red knob on top to “off.” Finally, wait for at least five minutes and turn the knob back to “on.” The pump will now be reset and should begin pumping water as normal.