How To Separate Cast Iron Pipe Joints

Cast iron pipe joints can be separated by using a chisel and hammer to break the joint apart. The chisel should be inserted into the joint and then tapped with the hammer to break the seal.

How To Separate Cast Iron Pipe Joints

Cast iron pipe joints are typically sealed with a sealant that is melted and poured into the joint. The sealant can be a compound such as lead and tin, or a modern polymer. One way to separate cast iron pipe joints is to use a heat gun to soften the sealant. The heat will cause the sealant to become liquid, and it can then be poured out of the joint. Another way to separate the joints is to use a plunger. The plun

-Tape measure -Pipe wrench -Crescent wrench -Sledge hammer -Screwdriver -Pliers

  • Wipe the surfaces of the pipes with a rag dipped in mineral spirits
  • Twist the pipes together and then pull them apart
  • Place a piece of newspaper over the joint

-Use a strap wrench to get a good grip on the pipe. -Hit the pipe sharply with a hammer to loosen the joint. -If the joint is still stuck, use a hacksaw to cut the pipe and then use a chisel to break the remaining pieces of pipe.


Frequently Asked Questions

How Do You Take Apart Cast Iron Pipe Fittings?

Cast iron pipe fittings can be taken apart using a hammer and chisel. First, the chisel is inserted into the seam between the two halves of the fitting. Then, the hammer is used to strike the chisel, splitting the fitting in half.

How Do You Remove Lead Joints From A Cast Iron Pipe?

Lead joints can be removed from a cast iron pipe by using a hacksaw to cut the joint, then using a chisel and hammer to remove the lead.

How Do You Separate Cast Iron Downpipes?

There are a few ways to separate cast iron downpipes. One way is to use a hammer and chisel to break the pipes apart. Another way is to use a saw to cut the pipes apart.


To Review

Cast iron pipe joints can be separated by using a hacksaw or a grinder.

Leave a Comment

Your email address will not be published.