How To Set Oxy Acetylene Regulators

Before you begin, make sure that you have read and understand the manufacturer’s instructions. The regulators must be set properly in order for the oxyacetylene welding system to function safely and efficiently. To set the regulators, first connect the hoses to the tanks. Next, open the tank valves slowly. Turn on the oxygen valve first and then the acetylene valve. Close the tank valves when the welding process is finished. To set the regulator, turn the adjusting screw on

How To Set Oxy Acetylene Regulators

Oxyacetylene regulators are designed to maintain a specific pressure in the gas line. There are two types of oxyacetylene regulators: the single stage and the two stage. The single stage regulator is designed to maintain a specific pressure and does not have a bypass. The two stage regulator has a bypass that allows it to adjust the pressure within a specific range. The first step in setting an oxyacetylene regulator is to identify the type of regulator. Once the type is identified

This procedure will require the following tools and materials: -Phillips head screwdriver -Oxygen regulator -Acetylene regulator -Hex wrench -Channel locks -Vice grips -Tape measure -Pipe wrench -Welding goggles

  • Open the acetylene cylinder valve completely
  • Select the required regulator
  • Open the oxygen cylinder valve completely screw the regulators onto the cylinders turn on the acetylene gas at the tank by turning the

-Check the hoses for cracks or damage and replace if necessary -Connect the acetylene hose to the left hand nut on the regulator and tighten -Connect the oxygen hose to the right hand nut on the regulator and tighten -Turn on the acetylene gas at the tank valve and then open the oxygen valve slowly -Adjust the regulators to the desired flame by turning the knobs until you have the correct reading


Frequently Asked Questions

How Do You Set An Oxy Acetylene Torch?

The oxy acetylene torch is set in a similar way to a blow torch. The oxygen and acetylene tanks are connected to the torch with hoses. The regulators on the tanks are then turned to the correct settings. The valves on the torch are then opened and the flame is lit.

What Should My Oxy Acetylene Regulators Be Set At?

The oxy acetylene regulators should be set at 4psi and 15psi, respectively.

What Should Oxygen And Acetylene Regulators Be Set At?

The oxygen and acetylene regulators should be set at the same pressure.


To Review

Setting the oxyacetylene regulators is a process that must be done correctly in order to ensure safe and proper operation of the welding system. First, connect the hoses to the regulators and tighten the fittings. Next, open the valves on the regulators fully. Finally, turn on the oxygen tank and adjust the regulator to the desired setting.

Leave a Comment

Your email address will not be published. Required fields are marked *