How To Set Oxy Acetylene Regulators

Oxygen acetylene regulators are a type of pressure regulator that are used to maintain a specific pressure in a gas line. There are two types of oxy acetylene regulators, the first is the welding regulator and the second is the cutting regulator. The welding regulator is used to weld metals together and the cutting regulator is used to cut metals. Both regulators have a knob on them that allows you to adjust the pressure.

How To Set Oxy Acetylene Regulators

When setting oxy acetylene regulators, ensure that the pressure gauge reads zero before attaching the hoses. Turn on the tank valves and check the gauges again; both should read about 15 psi. Close the tank valves and set the regulators to 15 psi by turning the knobs on the side of the regulators. Open the tank valves and check the gauges once more; they should now read about 30 psi. Close the tank valves and set the regulators to 30 psi. Finally, open

-An oxyacetylene regulator set -Oxygen and acetylene tanks -A welding torch

  • open the cylinder valves by turning the knobs in a counterclockwise direction. 2. close the oxygen valve on the regulator by turning it clockwise. this will isolate the oxygen supply. 3. open the

below – Check the pressure gauge to ensure that the pressure is set at the required level. – Turn off the oxygen and acetylene tanks. – Close the valves on the tanks. – Open the regulator valve on the oxygen tank. – Turn on the acetylene tank. – Open the regulator valve on the acetylene tank. – Adjust the pressure on both regulators to the required levels. – Close the valves on both tanks when finished.


Frequently Asked Questions

What Should Regulator Be Set At On Torch?

The regulator should be set at the “torch” setting.

What Is The Setting For Oxy Acetylene Torches?

The oxy acetylene torches are set up to use two different gases, oxygen and acetylene. The oxygen is used to help the flame burn hotter and the acetylene is used to help the flame stay lit.

What Are The 5 Things That You Should Remember In Setting Up Oxy Acetylene?

1. Make sure the hoses are properly attached and secure. 2. Open the acetylene tank valve slowly and completely. 3. Open the oxygen tank valve slowly and completely. 4. ignite the torch with the striker, then adjust the flame to the desired size. 5. Use caution when working with oxyacetylene, as it is a powerful and dangerous tool.


In Summary

To properly set oxy acetylene regulators, one must ensure that the required pressure is set on the regulator and that the hoses are properly connected. Additionally, one should visually inspect the connections for any leaks.

Leave a Comment

Your email address will not be published. Required fields are marked *