How To Wire A Subpanel In A Detached Garage

A detached garage is a great option for extra storage or parking, but it can be tricky to wire. Here is a guide on how to wire a subpanel in a detached garage.

How To Wire A Subpanel In A Detached Garage

The first step in wiring a subpanel in a detached garage is to shut off the main breaker in the home’s electrical panel. Next, remove the cover from the subpanel and identify the grounding bus bar. Strip about 1 inch of insulation from the end of each wire and twist the strands together. Attach one wire to the grounding bus bar and tighten the screw. Connect the other wires to the breakers in the subpanel and tighten the screws. Replace the cover on the subpanel

-wire cutter -wire stripper -needle nose pliers -screwdriver -level -tape measure -utility knife -hammer -chisel -jigsaw -circular saw -straight edge -clamps -channel locks -pliers -wire nuts -sub panel

  • Purchase a subpanel, breakers, wire, and connectors
  • Consult a licensed electrician to help you size and wire your subpanel
  • Cut a hole in the wall or ceiling of the garage to mount the subpanel

-The subpanel should be wired in accordance with the National Electrical Code (NEC) -A subpanel should have a ground wire connection to the main electrical panel and to the building’s grounding system -A subpanel should have a separate overcurrent device, such as a circuit breaker or fuse, to protect the circuit wiring -The subpanel should be mounted in an accessible location -Circuit wiring should be secured and supported in accordance with the NEC


Frequently Asked Questions

How Do You Wire A Sub Panel For A Garage?

Garage sub panels are typically wired with 240 volt service, with four wires – two hots, a neutral, and a ground. The panel will have a main breaker to protect the entire circuit, and branch circuits for outlets and lights. The sub panel should be installed by a licensed electrician.

How Do You Ground A Subpanel In A Detached Building?

There are a few ways to ground a subpanel in a detached building. One way is to run a ground wire from the main panel to the subpanel. Another way is to use a grounding rod.

Does A Subpanel In A Detached Garage Need A Ground Rod?

A ground rod is not necessary for a subpanel in a detached garage, but it is recommended to have one.


To Summarize

When wiring a subpanel in a detached garage, it is important to use conduit to protect the cable from moisture and other outdoor elements. Additionally, it is a good idea to use a ground fault circuit interrupter (GFCI) breaker to help protect against electrical shocks.

Leave a Comment

Your email address will not be published. Required fields are marked *